What are the different steps to change a kitchen faucet with sprayer?

Kitchens have always been an important part of the home. And to find a malfunction in this kitchen is not at all pleasing, especially when it comes to a faucet. Repairing it becomes more than a necessity. Repairing it becomes urgent, even vital. So, if you are facing problems with your faucet and want to change it, this article is for you. It will show you the steps you need to take to change a kitchen faucet.

Getting a replacement tap

The first thing you need to do is obviously to buy a new tap to replace the old one. There are different types of taps on the market. It is therefore important to make sure you choose the right one. This should not be too complicated. All you have to do is pay attention to the four small holes or the large hole next to a separate opening for the sprayer. Once you have found and purchased the tap, don't rush into it without reading the instruction manual at length. Find out more info by visite site.

Replace the old tap with the new one

This step requires concentration and some skill with the tools. Once you have purchased the faucet, you will need the proper tools such as - A basin spanner - A spanner - A supply hose - A bucket - Plumber's putty - A stitch With all these tools you can finally remove the old tap. But first, it is always best to turn off the water. You can then place the new tap in the opening. Make sure that you link the connections of the tap to the meter. To help you do this, feel free to use plumber's putty around the connections to fix them together. Once again, educate yourself and let the instruction book guide you. It will help you seal the connections and use the large nuts to secure the tap to the countertop.

Using braided hoses to connect water pipes

Here you will use the braided hoses to attach the water pipes. To do this, use your spanners to tighten the ends. Then remember to put the bucket under the sink and turn on the water from each water source. This will flush out any particles. Then connect the ends of the supply hose to the tap. But first make sure to turn off the water. Once this is done, pull the sprayer hose through the opening in the countertop and connect the sprayer hose to the central connection. You will also apply the wire sealing compound to this connection. Finally, check that the drain lines are tight, testing the valve and the sprayer. This last visit will ensure that everything will work.